Hi friends, how much are we enjoying the new Easter/Spring Release from Pretty Pink Posh Stamps!?

I went with the Water Can Shaker Dies today, I die-cut out the frame using both of the dies together from a light blue card stock.

Next, with the Layered Watering Can Floral Stencil and a standard A2 white panel on a grip mat. I ink blended on pink, orange, yellow, blue, and purple inks in a diagonal angle. I trimmed the panel down by 1/8 inch on all sides. With the outer die in the middle of the panel I ran it through in my P6 machine. Placing the panel on top of a card panel measuring the same as the stencil panel, I adhered the cut out piece in place with liquid glue.

Attaching a rectangle piece of acetate to cover the opening of the window in the back of the panel with double sided adhesive. Adding double thick foam around the window then filling up the well with the new Bunny Hop Shaker Beads. Attaching the panel to the back to seal up the well so none of the shaker beads fall out.

Back to the front I attached the blue frame over the top of the acetate.

Then with the Stitched Spring Flower Dies, I die cut out the flowers in the same colors as the beads. But I needed just a couple of smaller ones so with the Springtime Holder Addition Dies there are some perfect sized ones that I die cut out.

I stamped and white heat embossed the “Sending Spring Smiles” from the Easter Banner Greetings Stamp set and die-cut it out using the Banner Greetings 3 Dies.

Compensated affiliate links used when available. If you place an order after clicking on one of my links, I will receive a small commission at no cost to you. Make sure to accept cookies. Thank you for your support!

Thanks for stopping by and have a wonderful day!